Unlock Iphone 2G Using Quickpwn

Unlocking an iphone using quickpwn is piece of cake .

I will put step by step instructions. just you have to do is follow those steps.

So are you guys ready to unlock your iphone !!

Software needed to download first prior to starting an unlock process....

1. Quickpwn-this is the software that we use to unlock your iphone which can be downloaded from alot of sites for free!!!  please dont pay for this software!!!!

Download the required software from>>>http://www.iphonedownloadblog.com/iphone-downloads/

this site basically has everything that we need to unlock and iphone 2g using quickpwn.

2. Download the firmware you wish to put on your iphone .

    

3. download both bootloaders (3.9 and 4.6)

Now simply start the process.....

Connect your iPhone to your PC and open iTunes. Hold the Shift key and click “Restore” at the same time. You could click “Update” but that would eat up your disk space for nothing. See my previous post about that. So, when you click SHIFT + RESTORE, a window will pop up asking you to choose your firmware. Select the firmware you downloaded before Step 1. iTunes will then restore your iPhone to 2.1, which may take a while.

Once iTunes has restored your iPhone to 2.1, launch QuickPwn. Make sure your iPhone is connected to your PC and click the blue arrow.

Click the BROWSE button to locate your iPhone firmware you downloaded before Step 1. Select the firmware. QuickPwn will automatically check and make sure the ipsw (firmware) is correct. Click the blue arrow to go to the next step.

Now select what you want to do. You HAVE TO install Cydia. Using custom logos and installing Installer is pretty useless at the time. Also make sure you check the “Unlock Phone” checkbox. Click the blue arrow to continue.

You will then be asked to choose your BootLoader files you downloaded before step 1. Select them and click the blue arrow to continue.

QuickPwn will ask you to confirm that your iPhone is connected to your computer. Make sure it is and click the blue arrow to continue.

QuickPwn will now put your iPhone into recovery mode. Once it is in recovery mode you will be asked to: a) Hold the Home button for 5 seconds, b) Hold the Home and Power buttons for 10 seconds, c) Release the Power button and continuing holding the Home button until your iPhone is in DFU mode. QuickPwn gives you very detailed instructions to make it even easier for you!

Once QuickPwn detects your iPhone in DFU mode, it will start the pwning process.

Once pwned, QuickPwn will informa you that you successfully completed the pwnage process. Your iPhone will then proceed to run BootNeuter, which may take a few minutes, so be patient! Once done, your iPhone will reboot.

Done!